NOVASTAR control cards are more and more popular for that they can provide higher refresh rate and processing depth (grey level) especially in the application of small pixel pitch LED display screens.
Just like any led display control system, sometimes after a long time of operation, the control card may lose the configuration file (“.rcfg” file if NOVASTAR) and couldn’t get it from the original supplier. In this case, you’d need to set the parameters in the program and configure the new file.
Here we will explain how to configure this file.
A brief introduction of the steps:
1. Connecting 220(110)voltage main power cable to 5V 60A power supply;
2. Connecting 5 voltage power cable to 5V 60A power supply;
3. Connecting 5 voltage power cable to Novastar MRV336 receiving card;
4. Connecting flat cable to Novastar MRV336 receiving card;
5. Connecting 5 voltage power cable to P2.5 LED panel power interface;
6. Connecting flat cable to P2.5 LED panel signal interface;
7. Connecting Novastar sending box(card)between laptop (PC) and MRV336 receiving card;
8. The TB2 sending box is connected to the MRV336 receiving card with a network cable;
9. Use NovaLCT for smart settings;
10. Choose the correct option according to the content displayed by the P2.5 LED panel;
11. According to the specification of the P2.5 LED panel, select the parameters that match on NovaLCT;
12. P2.5 LED panel demo in this video: Size:320×160mm Pixel: 128×64 IC： ICN2153 Decoding： ICN2013